System does not boot from a hard disk 1. Table of Contents Chapter 1: Floppy Disk Connector The motherboard provides a standard floppy disk connector that supports K, K, 1. The setup guide will list the software available for your system, click on each software title to launch the installation program. Click on the Manual icon to browse for available manual. Remove all expansion cards except the video adapter.
|Date Added:||26 April 2004|
|File Size:||69.55 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Unlock a DIMM slot by pressing the retaining clips outward. Biostae the fan cable to the connector while matching the black wire to pin 1.
Fault tolerance is maintained by ensuring that the parity information for any given block of data is placed on a different drive from those used to store biosar data itself. It breaks up a large file into smaller blocks and performs disk reads and writes across multiple drives in parallel.
RAID 0 defines a disk striping scheme that improves disk read and write times for many applications. Check cable running from disk to disk controller board. System cannot boot after user installs a 1.
Select Software Installation, and then click on the respective software title. RAM maximal frequency, MHz. If beep codes are not generated when all other expansion cards are absent, one of the add-in cards is causing the malfunction.
Biostar N68S3 – motherboard – micro ATX – Socket AM3
The fan cable and connector may be different according to the fan manufacturer. D-Sub VGA on the back panel. Should one drive fail, the controller switches to the other drive. Avoid touching the components on motherboard or the rear side of the board unless necessary.
Performance is impaired during drive rebuilds. When the CPU is over heated, the motherboard will shutdown automatically to avoid a damage of the CPU, and the system may not power on again. Insert the Setup CD to the optical drive. Remove AC power line. Individual block data transfer rate same as a single disk.
Make sure both ends are securely plugged in; check the drive type in the standard CMOS setup. Optical output on the back panel Optical output on the back panel X.
Motherboard specification Biostar N68S3 Ver. 6.x
DisplayPort on the back panel. Optical output on the back panel. Triple-channel PCI Express mode. Reset your desired password or clear the CMOS data.
Biostar N68S3 Owner’s Manual |
Video controller presence Video controller presence X. Backing up the hard drive is extremely important. Coaxial output on the back panel. This equipment generates, uses, and can radiate radio bisotar energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Prepare a dry and stable working environment with sufficient lighting. Chipset model Chipset model X.
Video controller model Video controller m68s3 X. Hold the CPU down firmly, and then close the lever toward direct B to complete the installation. Make sure correct information is in setup.
Reformat the hard drive.